This is my latest attempt at making fettuccine with a new flour combo. It was quite good and worked fairly easily. The key is to knead it long enough and then let it rest.
CLICK ON PHOTO
2 cups all purpose flour
2 cups semolina flour
1 pinch of salt (see note)
6 extra large eggs
2 tablespoons olive oil
Sift (or whisk) the flours together. In another bowl, whisk the eggs and oil together until smooth. Mix the wet ingredients with the dry ingredients in your stand mixer. Here is where you might have to make some moisture adjustments because no two eggs have the same amount of moisture in them. If you mix for a few minutes and the dough still seems sticky, add another tablespoon of flour. If it seems dry and shaggy, add another tablespoon of water (or oil). When the dough starts to come away from the sides of your bowl cleanly, set your timer and knead the dough for about 8 minutes. After it has kneaded, wrap tightly in plastic wrap and let it sit, at room temperature, for at least 30 minutes to an hour. This will make the dough much easier to handle.
Pinch off pieces of dough and flatten it just a little in your hands. Dust it with flour before you run it through your pasta roller on the widest setting. Each time you run it through, fold the dough over onto itself, a couple of times and run it through again. Do this about three times before you start to reduce the thickness setting on your roller.
Now that you have run it through the widest setting a few times, reduce the thickness setting and run it through again. It will take about 3-4 thickness reductions to get it to a commercial thickness. Finally, dust it with flour (brush off excess with a pastry brush) and run it through your pasta cutter. Place pasta on a baking rack (or pasta rack) so that air can get to all sides of it.
If you cook it right away, it will take about 3-4 minutes in boiling salted water.
If you dry the pasta, it will take 8 to 10 minutes to boil.
NOTE: This recipe calls for a pinch of salt in the dough; however, my pasta roller (in big bold letters) says never put salt in the dough with this cutter. I'm not sure if it is harmful to the machine or what, but I don't want to take a chance, so I skip the salt and just boil the pasta in salted water, it seems just fine.
NOTE: If you are rolling this dough by hand, flour your counter and roll the dough out with small strokes in one direction...rolling it as thin as you can get it. Cut pasta with a pizza cutter. Use a pastry brush to dust off excess flour before you cut it.